If your Ford 2000 or 4000 series tractor is hunting at idle, surging under load, or won’t hold a steady RPM when you’re running the PTO, chances are your governor spring assembly has given up the ghost. This little assembly might look simple, but it’s the heart of your engine’s speed control system. When it’s working right, you don’t think about it—when it’s not, every job becomes a wrestling match with engine speed.
What You’re Getting
- Complete compensator spring assembly designed specifically for EAF12470A flyweight governors
- Direct replacement for worn or broken original springs that restores smooth engine operation
- Precision-calibrated spring rates that maintain proper governor response across all RPM ranges
- Quality construction that handles the constant cycling and vibration of farm work
Built for Real Farm Work
Ford 1000 Series tractors from the 2000 to 7000 models represent the backbone of mid-scale farming operations worldwide. These versatile workhorses, produced from 1965 to 1975, are commonly used for crop cultivation, livestock management, hay production, and general farm maintenance tasks. Whether you’re running a 2000 series for smaller jobs around the farm or putting a 4000 series through heavier cultivation work, steady engine speed is critical for consistent PTO operation and smooth hydraulic performance.
Made to Last
This assembly is built to work with the more modern flyweight governor system (EAF12470A) that replaced the older flyball governors used in earlier tractors. The springs are heat-treated and tested to maintain their tension through thousands of cycles, and the hardware is designed to stay put even when your tractor is working hard on rough ground.
Good to Know
This spring assembly only works with tractors that have been updated to the EAF12470A flyweight governor—it won’t work with the original flyball governor system used from 1953-1957. Installation typically requires removing the governor cover, so you’ll want to have a clean workspace and fresh gaskets on hand. Take photos before disassembly to make sure everything goes back together in the right order.
