If your old Ford N-series tractor is burning oil or losing compression, chances are the piston rings have seen better days. After decades of faithful service, those rings wear down and can’t seal like they used to. This complete ring set gets your 2N, 8N, or 9N back to running strong and pulling hard like it did when it rolled off the line.
What You’re Getting
- Complete ring set for one cylinder with standard 3-3/16 inch bore sizing
- Two compression rings at 3/32 inch and two oil control rings at 3/16 inch thickness
- Quality construction that handles the heat and pressure of daily farm work
- Direct replacement for your worn original rings—no machine work needed
Built for Real Farm Work
These rings are designed for the 119.7 cubic inch flathead engine that powered thousands of Ford N-series tractors from the late 1930s through the early 1950s. Whether you’re using your tractor for mowing, cultivating, or running the PTO, this ring set restores proper compression and oil control so you can keep working.
Made to Last
Farm tractors don’t get pampered, and these rings are built to handle it. They’re made from durable materials that resist wear and maintain their seal even under the constant heating and cooling cycles of regular use. You’ll get years of reliable service from this replacement set.
Installation Notes
This set includes rings for one cylinder, so you’ll need four sets total for a complete engine rebuild. Ring installation requires removing the pistons, so it’s a good time to check your cylinder walls and bearings while you’re in there. Take your time with ring gap measurements—proper fitting makes all the difference in performance and longevity.
